Viking E-32T Series Product Manual page 25

A. Making a Call
When the Call button is pressed, the E-32T-SS-IP dials the first number in its list. If the call fails (busy, rejected or other
SIP call failure) and redial on busy is enabled, the next number will be dialed. If redial on busy is disabled, the E-32T-
SS-IP will hang up and go into its idle state.
Outbound calls will ring until the ring timeout is met, or the call is answered.
When the call is answered, two-way voice is established. The call timer starts. The called device can enter the relay
commands if door strike mode is enabled. Door strike code starts a momentary relay closure, and the latching commands
(on code/off code) will latch the relay. The call can be ended with the call button, a DTMF "#" or remotely with a call
ended signal. Otherwise the call timer ends the call when its value is met.
B. Incoming Calls
The E-32T-SS-IP will handle incoming calls based on the Inbound Call Mode Setting:
Setting
Disabled
Auto Answer
Auto-Answer-Secure
Loud Ringing
13 - Operation
Description
All inbound calls are rejected.
Inbound calls are auto answered with the Microphone and Speaker enabled. If an Access Code is set,
it must be entered to control the relay with DTMF code.
Inbound calls are auto answered with the Microphone and Speaker enabled. The Access Code must
be usedto enable communication and DTMF relay control.
A Loud Ringing signal is emitted from the speaker on inbound calls. The call can be answered by
pressing the 'Call' button on the panel
25