Viking E-32T Series Product Manual page 14

Configure Tab
Advanced Phone Settings
The advanced phone settings page contains
additional phone features from legacy Viking
products. These settings are used before and
during SIP video calls.
Setting Description
This setting determines how the speaker on the E-32T-SS-IP will function.
Speaker Mode
On
Speaker Mode
Silent Monitor
Off Until
Answered
The Id Number is an In-band or RFC 2833 DTMF string sent to the calling party after
Id Number
a "Q" is dialed. Leave blank to disable this feature.
When set to Enabled, the device will make a SIP call once a day at a programmable
Daily Test Call
hour.
Test Call Start Time The time of day the unit will make the Daily Test Call.
Alternating Switch When enabled, a VoIP call can be ended with the button. When disabled, calls can
Action only be started with the button.
During outbound calls, the LED can turn on when the call is connected, or wait until a
Call Led Control
"Q" is received.
Vox Sensitivity 1-10. Higher values make the unit more sensitive to audio from the called party.
1-10 (100 mS to 1 S). The amount of switching time to switch between talk and listen
Vox Delay
modes.
Description
The speaker is active during inbound and outbound calls.
The speaker is will be muted during inbound and outbound calls.
The speaker will remain off until an outbound SIP call is connected. On
inbound calls the speaker will function normally.
14
Factory Default
On
Blank - disabled
Disabled
02:00 AM
Enabled
Automatic
5
5 (0.5 seconds)