Graco LD Series Instructions Manual page 8

Installation
Installation Mounting Options
All Mountings
NOTE: Reels perform best when arm allows hose to pull
straight off the spool as shown in F
F . 2
IG
To reduce the risk of injury, be sure the mounting sur-
face is strong enough to support the reels, weight of
the lubricants and stress caused by hard pulls on the
service hoses. See Technical Data, page 31 for
weights of hose reel assemblies.
NOTE: Always use all 4 large flat washers with 4 bolts to
mount the hose reel pedestal to any surface.
1. Select the reel bank mounting location.
• For high ceilings, suspend a suitable support
structure for the reels, so the hoses will be long
enough to reach your service area.
• A reel bank mounted in a one-lift service bay
should be at least 6-ft (1.9m) from the center
line of the lift (F
IG
• In a one-lift bay, mount the reel bank at least 6
feet (1.9 m) from the center line of the lift. In a
two-lift bay, mount the bank equal distance
between the lifts.
8
. 2.
IG
. 5).
• A bank of all motor oil reels should be mounted
about 5 ft (1.5m) from the center of the lift,
toward the front of the lift rails (F
EE
FF
ti13258
*HP and HR Models Shipping Position
**EE
FF
**HS Models Shipping Position
F . 3
IG
2. Determine the desired position of the roller support
arm (a) (F
• The hose reel is factory-assembled and shipped
with the roller support arm (a) in position AA
(HR & HP Models) or EE (HS Models) (F
If that position is desired, skip step 3.
DD a
DD
a
. 3).
IG
. 5).
IG
AA*
BB
b
CC
ti12199a
AA
BB
b
c
CC
ti13394
. 3).
IG
313431A