Graco LD Series Instructions Manual page 13

Ceiling Mounting to I-Beam without Drilling Holes - All models
(Order Mounting Bracket Kit: 204741 for open or enclosed reels.)
NOTE: For mounting 1-3 reels, two kits are required. For mounting 4-6 reels, three kits are required.
FN Description
201 WASHER, lock, spring
202 SCREW, cap, hex head
203 SCREW, cap, hex head
204 NUT (not shown)
205 NUT, spring clamp
206 CLAMP, beam
207 CHANNEL, unistrut
1. Secure mounting brackets (D) to the channel. Use
two mounting brackets for each 1- to 3 capacity
mounting channel (103). (Use 3 brackets for 4-6 reel
channels.)
2. Position the adjustable clamps (206) of the mount-
ing brackets over the I-Beam (A), and tighten them
securely (F . 8).
IG
3. HR and HP Model Reels only (F
Slide hose reel onto the base plate (104) and install
the hold-down plate (101), washer (103) and cap-
screw (102). Tighten the screw firmly.
NOTE: For enclosed reels, use the Enclosure Kit Base
Plate (Part No. 302, page 18).
4. If you are installing permanent supply lines, drill 1.5
in. (38 mm) diameter holes through the ceiling
toward the inlet side of the reels.
313431A
5. Continue installation following steps 5 - 10 of Over-
Qty
2
2
2
2
2
2
1
. 6, page 11):
IG
F
head Installations instructions, beginning on page 9.
ti13188
206
207
202
. 8
IG
Installation
203
206
205
103
201
202
A
203
201
D
ti13187
D
205
13