Graco LD Series Instructions Manual page 19

3. Loosen and remove screws (301) holding hose reel
guide (d) to hose reel guide arm (c). Completely
remove hose reel guide and hose stop (F
301
F . 14
IG
4. Slide one spring nut (310) over each position (a)
hole on the side panels (307 & 308) as shown in
F . 15. Refer to the enlarged view shown in F
IG
15A for proper clip orientation.
5. Slide the two panel sections (307 & 308) together,
aligning clips (310)/holes (a) with mating holes (b) in
panel section. Insert and tighten screws (309) to join
the two side panels together.
6. Align opening for hose reel guide (d) in panel (307)
with end of guide arm (c).
313431A
7. Reinstall hose reel guide (d) to arm through the
opening in panel (307). Install and tighten 4 screws
. 14). (301).
IG
8. Install 4 thumb screws (306) to join side panels to
hose reel base (302).
NOTE:
• If installing end panels, continue with steps 9 - 11. If
not installing end panels, continue installation with
d
step 12.
• When installing side panels on a bank of hose reels
(2 or more) one end panel is installed on each end
of the series of reels.
c
9. Slide one clip (401) over each hole (a) on two side
panels (403). Refer to the enlarged view shown in
F . 15A for side panels to proper clip alignment.
IG
10. Match holes (a) in end panel (403) to mating holes
(b) in a side panel. Install and tighten screws (402)
to join the end and side panels together.
11. Clean and dry off surface of each end panel. Attach
a Graco label (404) to the center of each end panel.
.
IG
12. Position hose stop so hose extends far enough for
all operators to reach dispensing valve.
13. Insert screws through hose stop and tighten nuts to
securely hold hose stop in place.
14. Install meter or dispense valve to end of hose follow-
ing instructions provided with the dispense equip-
ment.
Installation
19