COMSPHERE 6800 Series Nework Management System
2. TYPE: the number of the link that is to be the SDL port
3. If a parameter on your screen does not match one shown above, select the option
4. TYPE: the number of the correct parameter
5. To save the parameters after you have corrected them,
6. Go to Entering Direct Routes.
Entering Direct Routes
The 719 NETWORKER must have a routing table that indicates the link or channel port used to
communicate with other nodes in the network. You must specify the other nodes in the network
and the NETWORKER link used to access each of these nodes. For the example used in this
section, the other nodes can be accessed only through Link 0.
To configure direct routes for the NETWORKER,
1. From the Configuration menu,
2-38
PRESS: Enter
The Data Link Parameters screen appears. The parameters on your screen should match
those shown below:
PARAMETER
Data Link
Satellite
Link Connected To
Parallel Links
Link State
Load Sharing Link
(parameter) number that does not match,
PRESS: Enter
The screen for that parameter appears.
PRESS: Enter
TYPE: S
PRESS: Enter
The system returns to the Configuration menu.
TYPE: 5
PRESS: Enter
The following prompt appears:
(Node 101) enter network number >
August 1994
SETTING
Modem Clock — 9600 bps
Inactive
networker
None
In Service
Inactive
6800-A2-GB21-10