File Contents Window - Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual

5. Click on the OK button.
Setting a New File as the Destination for a Function
You may create a new file when you select the source or destination of an MRT function. The new
file is created as an empty file and can only be a destination for saving a routing table. A routing
table cannot be retrieved from that new file until a routing table has been saved to it.
To set a new file as the destination for a function, perform the following steps:
1. Click on Select Source/Dest. from the Table pull-down menu.
2. Click on Routing Table File.
6800-A2-GB21-10
Figure 1-4. File Contents Window
The name of the routing table file and the date it was last edited appear in the Routing
Table Information Area.
The sub-menu appears requesting a choice between the Network or a Routing Table File.
The Routing Table Files dialog window appears (see Figure 1-3). This window shows a list
of existing routing table files and a selection area where other file names are entered.
August 1994
Managing Multiplexers
1-51