Performance Measurements - Paradyne COMSPHERE 6800 Series Multiplexer Management And Configuration Manual

Performance Measurements

To measure the performance of facilities and channel groups, generate the appropriate report by
executing the following commands.
Channel Group Performance Report (cgpr)
DDS Channel Performance and Status (ddscps)
DDS Channel Trouble Codes (ddsctc)
Facility Errors Report (fer)
Facility Performance Report (fpr)
Node Errors Report (ner)
Time Slot Performance Report (tspr)
6800-A2-GB21-10
Displays the number of failed seconds and errored seconds of each of the channel groups
in the specified node since the last statistical reset.
Summarizes DDS channel performance and status information.
Summarizes the key control codes received from the network on each DDS channel at the
node.
Displays the number and type of facility errors that have occurred on a specified facility
since the last statistical reset.
Reports, in tabular form or in a graphical display, the number of errored and failed
seconds of a T1 facility over the last 24 hours.
Displays the number of node errors detected at a multiplexer node.
Reports the performance of 740 serial synchronous time slot – those connected from a
740 node to a 74x-56K node carrying 56 kbps serial synchronous channel groups.
August 1994
Managing Multiplexers
1-89