Paradyne COMSPHERE 6800 Series Communications Products Support Configuration Manual page 31

COMSPHERE 6800 Series Network Management System
Command Device(s)
Exception Report APL, DDD,
(er ) DDS
Loopback (lo) APL, DDD,
DDS
Make Busy (mkb) DDD
Modem Bit Error APL, DDS,
Rate Test (mbert )
DDD
Offline Test (ot ) DDS
Receive Signal APL
Spectrum (rss)
Remote Digital DDD
Loopback (rdl )
APL
Send Tone (snt )
Service Line (sl) DDD
Transmit Test DDD, DDS
Pattern (ttp)
You can combine a series of commands or tests into a routine. This routine can also be used in an
alert driven routine. For more information on routines, refer to the COMSPHERE 6800 Series
Network Management System User's/System Administrator's Guide.
1-22
Table 1-5
(2 of 2)
Network Device Commands
Description
Used to obtain tabular listings of
command results statistics for a
specified command.
Used to place a device into and out of
one of five loopback states.
Used to enable/disable direct distance
dialing modems.
Used to locate primary data channel
problems on a device by calculating
the bit error rate.
Used to test primary and secondary
data channel circuits on a DSU.
Used to measure the inbound receive
signal levels at various frequencies.
Used to place a device into and out of
a digital loopback state.
Used to transmit a selected tone in a
single direction on the primary data
channel.
Used to allow a ninth service
telephone line to be assigned to one
of the eight DDD modems in a carrier.
Used to turn the test pattern generator
in a device on or off.
January 1997
Results
Displays the overall results of
each test and device-specific
information for each device
tested.
Indicates if the command
executed successfully.
Indicates if the command
executed successfully.
Indicates if the command
executed successfully. May
also display total seconds for
test, errored seconds, number
of bits, errored bits, and bit
error rate, depending on the
entries in the input form.
Test results are expressed as
pass or fail.
Indicates if the command
executed successfully or the
level at which various
frequencies can display,
depending on the entry in the
input form.
Indicates if the command
executed successfully.
Indicates if the command
executed successfully.
Indicates if the command
executed successfully.
Indicates if the command
executed successfully.
6800-A2-GB20-20