Paradyne 3800 Release Note page 76

28. The system prompts:
Installing the NMS Full-Feature Workstation Application Software with EtherLink II Card
A diskette is provided to install the full-feature workstation application software on your Altos
486DX/33, Altos SX/20, or a 386-based processor. To install the software, perform the following
steps:
1. Turn on your system. Insert the disk labeled 6800 FFW Application Volume 1 into the
2. At the C: prompt,
Xsetup will need to copy some additional files to go with your network files
Press any key to continue
PRESS: Enter
Searching archive for files. Please wait . . .
Press any key to continue
PRESS: Enter
eXodus Setup is now finished
Create a HOSTS file that has the same name as the one you specified, before you
start eXodus.
See the Installation & Operation Guide for more details
eXodus Install Complete
Press any key to continue
PRESS: Enter
a: drive.
TYPE: cd C:\EXODUS
PRESS: Enter
TYPE: a:install
PRESS: Enter
The current directory should be "\xone" if you have installed XONE
or "\exodus" if you have installed EXODUS.
If current directory is not "\xone" or "\exodus"
Please break out of the installation by typing
Ctrl-C
Press any key to continue
PRESS: Enter
75