Paradyne 3800 Release Note page 63

Installing SuperTCP Version 4.0
Before installing this software, verify that the hardware was configured properly to run eXceed 4
software. To install SuperTCP Version 4.0, perform the following steps:
1. If Windows is not running, type win at the DOS prompt.
2. Insert the diskette labeled SuperTCP Installation Disk into the a: drive.
3. Select Run from the Program Manager's File menu.
4. Type a:\install in the Run Dialog box. Click on OK. The Package Authentication dialog
5. Enter the Serial Number and Authentication Key. (These unique numbers come in your
6. Select Default. The Batch Setup dialog box appears.
7. Select Yes in response to the question "Do you want your C:\AUTOEXEC.BAT file
8. Click on OK. The SuperTCP Minimal Configuration dialog box appears.
9. Enter ffw_name for "This Machine Name" and 1.1.1.3 for the IP Address. Do not change
10. Insert the diskette labeled SuperTCP NDIS/Packet Drivers into the a: drive and click on
11. Select Intel EtherExpress 16 Family of Adapters if the Intel EtherExpress card is
12. Click on OK in response to the message "CONFIG.SYS has been modified..." The
13. Click on OK. The SuperTCP Kernel for Windows Version 4.00 R2 dialog box appears.
14. Click on Close. A notice box appears indicating that ''Devices were changed in the
15. Click on OK. A dialog box labeled IMPORTANT appears indicating that ''You must
16. Click on OK.
17. Exit Windows.
box appears.
software package.) Click on OK. A dialog box for Default or Custom Installation selection
appears.
modified so that super–TCP can automatically start?" The Time Zone dialog box appears.
any other values. Click on OK. The Insert Disk dialog box appears.
OK. The Network Adapters dialog box appears.
configured or select Proteon ProNET–4/16 p1390 v2.07 if the Proteon Token ring card is
configured and click on OK. The NDIS Configuration dialog box appears.
Interface 1 dialog box appears.
SYSTEM.INI file.."
reboot your computer..."
62