Paradyne 3800 Release Note page 64

18. Do one of the following:
Installing eXceed 4
Before installing this software, verify that the hardware was configured properly to run eXceed 4
software. Verify that SuperTCP is properly installed. To install eXceed 4, perform the following
steps:
1. If Windows is not running, type win at the DOS prompt.
2. Insert the diskette labeled eXceed 4 DISK 1/11 into the a: drive.
3. Select Run from the Program Manager's File menu.
4. Type a:\setup in the Run Dialog box and click on OK. The eXceed 4 - Setup dialog box
5. Click on OK. A dialog box appears with Setup Type defaulted to Personal and Method
6. Click on OK. A dialog box appears requesting your home directory. The default is
7. Click on OK. A dialog box appears requesting your user directory. The default is
8. Click on OK. A dialog box appears saying "Winsock was detected. Would you like to
9. Click on No. A dialog box appears with all setup options selected properly.
10. Click on Start. A dialog box appears requesting distribution diskette #2.
For Intel EtherExpress card configurations, reboot the system and continue with the
Installing eXceed 4 procedure.
For Token Ring card configurations:
Insert the diskette labeled 6800 Token Ring FFW Application into the
a: drive.
At the DOS prompt, type
copy /y a:\*.* c:\supertcp.
With a text editor, edit the c:\config.sys file changing the line:
Device=c:\supertcp\NDIS139.DOS
to
Device=c:\supertcp\NDIS39XR.DOS.
Reboot the system and and continue with the Installing eXceed 4 procedure.
appears.
defaulted to Express.
C:\EXCEED.
C:\EXCEED\USER.
install additional transport interfaces?"
63