Paradyne 3800 Release Note page 69

Chapter 5
Using Whitepine Exodus with Existing Hardware
The following procedures should be amended to Chapter 5 of the installation manual:
For installing the Token Ring software on the Full-Feature Workstation, see Token Ring
Installation When Using Either X-One or Exodus Software at the end of this section.
Installing the Whitepine Exodus Software Package with EtherLink II Card
To install the Whitepine Exodus software package, perform the following steps:
1. Insert the Whitepine Exodus installation disk into the drive and
2. The system prompts:
3. The system prompts:
4. The system prompts:
Installing the Whitepine Exodus software package with EtherLink II Card
Installing the NMS Full-Feature Workstation Application software with EtherLink II Card
Installing Whitepine Exodus software package with a StarLAN 10 NAU
Installing the NMS Full-Feature Workstation Application software with
StarLAN 10 NAU
Network configuration of full-feature workstation
TYPE: A:install
PRESS: Enter
Enter the floppy drive to use [A:]:
PRESS: Enter
Enter the destination drive to use [C:]:
PRESS: Enter
Enter the destination directory to use [\EXODUS]:
PRESS: Enter
If the directory, C:\EXODUS, does not exist the system prompts:
The directory C:\EXODUS does not exist. OK to create it? (y/n) [y]
TYPE: y
PRESS: Enter
68