Paradyne 3800 Release Note page 43

Some Globalyst 575 configurations run the Whitepine Exodus software. For information on these
workstations, refer to the Using the Globalyst 575 Running Whitepine Exodus Software section.
Some Globalyst 575 configurations and all of the Globalyst 520 configurations run the eXceed 4
software. For information on these workstations, refer to the Using the Globalyst 520 and 575
Running eXceed 4 Software section.
Check for the eXceed or EXODUS directory on your Globalyst machine to verify which software
is loaded on your system.
Using the Globalyst 575 As a Basic-Feature Workstation
There are no on-site configuration or user modifications required on the Globalyst 575 when used
as a basic-feature workstation. However, you may verify that procedures in the following sections
were performed to switch off cache and properly configure the factory-installed ATI Graphics
Ultra+ Video card:
Refer to the Using the Globalyst 575 As a Full-Feature Workstation Running Whitepine Exodus
Software section for these procedures . For a complete description of the PC hardware or
instructions on connecting PC components, refer to the manufacturer's user's guide that
accompanies the hardware.
Using the Globalyst 520 As a Basic-Feature Workstation
There are no on-site configuration or user modifications required on the Globalyst 520 when used
as a basic-feature workstation.
For a complete description of the PC hardware or instructions on connecting PC components, refer
to the manufacturer's user's guide that accompanies the hardware.
t
Intel EtherExpress 16 network interface card (pre-installed on full-feature workstations)
Token Ring card may be configured depending on user requirements.
MS-DOS 6.22 and MS-Windows 3.11.
Configuring the ATI Graphics ULTRA+ Card
Switching off Cache on the Globalyst 575
42