Philips HomeRun Aqua XU3000/01 Manual page 9

Important: Philips values and respects your privacy. A link to our privacy notice
can be found in the app before registering.
Setting up the Wi-Fi connection
Before you begin: make sure that the robot and your mobile device have
good Wi-Fi coverage.
1 Press the 'Add robot' button in the app and follow the instructions.
2 Pair the robot with the WiFi in the app.
3 Press and hold the on/off button and home button at the same time for three
seconds. The lights in the buttons will flash orange to indicate that the robot
3
sec
is in Wi-Fi set-up mode.
4 Click the join button if it's visible in the app to connect with the 'Philips
robot' network.
Note: If the join button is not visible in the app, leave the app and go to WiFi
under 'Settings' on your mobile device. There you can select the 'Philips robot'
network and connect to it).
Philips HomeRun
If the Wi-Fi pairing fails:
-
Check your Wi-Fi connection.
-
Check if you selected the correct model.
-
Check if you entered the correct Wi-Fi password.
-
Check if the robot is still in Wi-Fi set-up mode.
Note: You can recognize this if the lights in the two buttons on the robot are
still flashing orange.
Settings
WLAN
Philips robot_XXXX
English
11