Table of Contents
Advertisement
Note:
If "Boot option filter" is set to "UEFI and Legacy" or "UEFI only" and Quiet Boot
is set to enabled, BGRT Logo field will show up for configuration. Refer to the
Advanced > CSM Configuration for more information.
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Main
Advanced
Chipset
Security
Boot
Boot Confi guration
Setup Prompt Timout
1
Bootup NumLock State
[On]
Quiet Boot
[Enabled]
Boot Option Priorities
BGRT Logo
[Disabled]
Driver Option Priorities
Version 2.20.1271. Copyright (C) 2018 American Megatrends, Inc.
BGRT Logo
It is used to enable or disable to support display logo with ACPI BGRT table.
Chapter 3 BIOS Setup
Chapter 3
Save & Exit
Boot Graphics Resource
Table
Select Screen
Select Item
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Save & Exit
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Main
Advanced
Chipset
Security
Save Options
Save Changes and Reset
Discard Changes and Reset
Restore Defaults
Boot Override
Save Setting to fi le
Restore Setting from fi le
Version 2.20.1271. Copyright (C) 2018 American Megatrends, Inc.
Save Changes and Reset
To save the changes, select this field and then press <Enter>. A dialog box will
appear. Select Yes to reset the system after saving all changes made.
Discard Changes and Reset
To discard the changes, select this field and then press <Enter>. A dialog box will
appear. Select Yes to reset the system setup without saving any changes.
Restore Defaults
To restore and load the optimized default values, select this field and then press
<Enter>. A dialog box will appear. Select Yes to restore the default values of all the
setup options.
Save Setting to file
Select this option to save BIOS configuration settings to a USB flash device.
Restore Setting from file
This field will appear only when a USB flash device is detected. Select this field to
restore setting from the USB flash device.
51
Boot
Save & Exit
Reset the system after
saving the changes
Select Screen
Select Item
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
www.dfi .com
Advertisement
Table of Contents
