Table of Contents
Advertisement
S/PDIF Connector
SPDIF out
Ground
SPDIF in
+5V
S/PDIF
1
5
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
Chapter 2 Hardware Installation
Chapter 2
Battery
Battery
A61
A61
The lithium ion battery powers the real-time clock and CMOS memory. It is an auxiliary source
of power when the main power is shut off.
Safety Measures
• Danger of explosion if battery incorrectly replaced.
• Replace only with the same or equivalent type recommended by the manufacturer.
• Dispose of used batteries according to local ordinance
30
Battery
Battery
A61
A61
.
www.dfi .com
Advertisement
Table of Contents
