Table of Contents
Advertisement
Trusted Computing
This section configures settings relevant to Trusted Computing innovations.
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Advanced
Confi guration
Security Device Support
[Enable]
NO Security Device Found
Version 2.20.1271. Copyright (C) 2018 American Megatrends, Inc.
Security Device Support
This field is used to enable or disable BIOS support for the security device. O.S will
not show the security device. TCG EFI protocol and INT1A interface will not be
available.
Chapter 3 BIOS Setup
Chapter 3
NCT6106D Super IO Configuration
This section is used to configure the I/O functions supported by the onboard Super I/O chip.
Enables or Disables
BIOS support for secu-
rity device. O.S will not
show Security Device.
TCG EFI protocol and
INT1A interface will not
be available.
Select Screen
Select Item
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
40
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Advanced
NCT6106D Super IO Confi guration
Super IO Chip
NCT6106D
[Second]
WatchDog Timer Unit
0
SuperIO WatchDog Timer
Serial Port 1 Confi guration
Serial Port 2 Confi guration
Serial Port 3 Confi guration
Serial Port 4 Confi guration
Serial Port 5 Confi guration
Serial Port 6 Confi guration
Version 2.20.1271. Copyright (C) 2018 American Megatrends, Inc.
WatchDog Timer Unit
Select WatchDog Timer Unit: Second or Minute.
SuperIO WatchDog Timer
Set SuperIO WatchDog Timer Timeout value. The range is from 0 (disabled) to 255.
Serial Port 1 Configuration to Serial Port 6 Configuration
Set the parameters of serial port 1 (COMA) to serial port 6 (COMF).
Aptio Setup Utility - Copyright (C) 2018 American Megatrends, Inc.
Advanced
Serial Port 1 Confi guration
Serial Port
[Enabled]
Device Settings
IO=3F8h; IRQ=4;
RS485 Auto Flow
[Disabled]
Version 2.20.1271. Copyright (C) 2018 American Megatrends, Inc.
WatchDog Timer Unit
Selection
Select Screen
Select Item
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Enable or Disable Serial
Port (COM)
Select Screen
Select Item
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
www.dfi .com
Advertisement
Table of Contents
