Table of Contents
Advertisement
7. Attach the rod end link assembly to the pivot arm assembly and work arm assembly, then tighten hardware to
20-25 ft-lbs (27-34 Nm)..
8. Make sure the work arm assembly is centered on the bumper of the work arm stop assembly. If not, adjust the work
arm stop assembly (see Step 2).
9. Make sure the work arm assembly is centered on the bumper of the work arm stop assembly. If not, adjust the rod
end link assembly (see Step 7).
Item
1
2
3
4
5
Item
1
2
Work Arm Stop Assembly Bumper
Item
1
2
Work Arm Stop Assembly Bumper
Page 13 of 21
Description
M10 x 1.5 x 25mm Screw
3/8 Washer
Rod End Link Assembly
Work Arm Assembly
Pivot Arm Assembly
Description
Work Arm Assembly
Description
Work Arm Assembly
Qty.
2
2
1
1
1
Qty.
1
1
Qty.
1
1
Advertisement
Table of Contents
