Table of Contents
Advertisement
Connecting to a System Terminal
An optional system maintenance terminal may be attached to your Hotwire 799x endpoint
through the modular jack on the rear panel. The system maintenance terminal allows you to view
the status of the unit and change configuration options. The terminal must be a
VT100-compatible terminal or a PC running terminal emulation software.
Procedure
To connect your unit to a system terminal:
1
Connect the 9-pin end of the supplied terminal cable into a COM port on your PC.
2
Plug the other end into the modular jack on the rear panel.
3
Set the communication parameters on your PC or terminal to:
— 9600 baud
— 8 bit characters
— no parity
— 1 stop bit
— no flow control
4
Press Enter from your terminal or PC to activate the Main Menu for the attached unit.
The system runs diagnostics and status checks. After a few moments, the Main Menu or
Logon screen appears on your terminal.
main
-----------------------------------------------------------------------------
Ctrl-a to access these functions
8
Access Level: Administrator
MAIN MENU
Status
Test
Configuration
Control
Hotwire TDM SHDSL Endpoints
Model 799x
Exit
System Operational
7990-A2-ZN10-30
Advertisement
Table of Contents
