Table of Contents
Advertisement
Table 1:
DSL Interface Options (2 of 2)
Start Up Margin
Possible Settings: 0dB – 15dB
Default Setting: 4dB
Specifies the Signal to Noise Ratio (SNR) margin a port must exceed to successfully train up
with the remote unit.
Max DSL Rate
Possible settings depend on whether Spectrum Management is enabled. Determines the
maximum speed of the DSL line when in Adaptive Rate mode (Max DSL Rate does not equal
Min DSL Rate).
Min DSL Rate
Possible settings depend on whether Spectrum Management is enabled. Determines the
minimum speed of the DSL line when in Adaptive Rate mode (Max DSL Rate does not equal
Min DSL Rate).
EIA-530 Payload Rate (for Model 7996 only)
Possible Settings: 64, 128
Default Setting: [Highest multiple of 64 kbps supported by the DSL Line Rate]
When the remote STU-R has an EIA-530-A interface, the Payload Rate set on the STU-C
determines the port speed of the synchronous port of the STU-R. Only 64 and 128 kbps are
selectable, otherwise this field is read-only.
Remotely Initiated Loopback
Possible Settings: Enable, Disable
Default Setting: Enable
Specifies whether the endpoint will respond to a loopback command from the access card.
Peer IP Address
Possible Settings: 001.000.000.000 – 223.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the peer IP address for the remote management link on the DSL loop.
Circuit Identifier
Possible Settings: ASCII text field, Clear
Default Setting: [blank]
Uniquely identifies the circuit number of the transmission vendor's DSL line for
troubleshooting purposes.
7990-A2-ZN10-30
Hotwire TDM SHDSL Endpoints
13
Advertisement
Table of Contents
