Device Management; Device Information - Eaton NetDirector B064-008-01-IPG Manual

OSD Operation

Device Management

The Device Management section allows Super Administrators, and Administrators/Users who have been given permission, to
configure and control the KVM switch. When the Device Management icon is selected, it opens with the Device Information page
displayed.
Note: If you do not have permission to configure the KVM switch, the Device Management icon will not appear when you log onto the KVM.

Device Information

The Device Information page displays general information
about the settings of the KVM switch, and allows you to
configure settings related to the KVM's dual power supplies
and temperature sensors.
The following table describes the contents of the Device Information page.
Note: B064-008-01-IPG and B064-016-01-IPG KVMs Only – Power Supply Detection, Power Supply 1 and Power Supply 2 are the only Environment
Information fields that are displayed.
Item Description
Device Name The port name assigned to the KVM switch is displayed here.
MAC1 Address The B064- Series KVM switch contains two network interfaces. The MAC address of the first network interface
is displayed here. The KVM MAC addresses are also displayed on the bottom panel of the KVM switch.
MAC2 Address The B064- Series KVM switch contains two network interfaces. The MAC address of the second network
interface is displayed here. The KVM MAC addresses are also displayed on the bottom panel of the KVM
switch.
Firmware Version The firmware version of the KVM switch is displayed here.
Main FPGA The Main Field-Programmable-Gate-Array (FPGA) is displayed here.
Console FPGA The Console Field-Programmable-Gate-Array (FPGA) is displayed here.
Note: Does not apply to the B064-008-01-IPG & B064-016-01-IPG KVMs.
Video Driver The Video Driver version is displayed here.
IP Address1 The IPv4 IP address of the first network interface is displayed here.
Subnet Mask 1 The IPv4 Subnet Mask of the first network interface is displayed here.
Gateway 1 The IPv4 Gateway of the first network interface is displayed here.
Preferred DNS Server 1 The IPv4 Preferred DNS Server of the first network interface is displayed here.
Alternate DNS Server 1 The IPv4 Alternate DNS Server of the second network interface is displayed here.
Note: Applicable to the B064-008-01-IPG and B064-016-01-IPG KVMs only.
IPv6 Address 1 The IPv6 IP address of the first network interface is displayed here.
IPv6 Subnet Prefix The IPv6 Subnet Prefix Length of the first network interface is displayed here.
Length 1
Power Supply The B064- IPG KVM features dual power supplies. Checking this checkbox will cause the KVM to beep
Detection when receiving power from one source, and a message will appear on the local console screen asking you
to confirm that you are aware of the situation.
Power Supply 1 The icon to the right of this is gray when power supply 1 is not receiving power. It is blue when power
supply 1 is receiving power.
Power Supply 2 The icon to the right of this is gray when power supply 2 is not receiving power. It is blue when power
supply 2 is receiving power.
35