Specifications
Serial Adapter Pin Assignments
The table below shows the pin assignments for the RJ45 to DB9 Adapter (DTE to DCE) that comes with the unit.
Switch (RJ45)
Pins
Modem (DB9)
RTS
1
DTR
2
TXD
3
CTS
4
GND
5
RXD
6
DCD
7
DSR
8
9 NC Not Used
Fan Location & Speed Information
The B064-Series KVM switch contains 6 fans, whose location
is shown in the image below.
Temperature Sensor Location
The location of the KVM switches for temperature sensors is shown in the image below.
Note: The temperature inside the case can be higher than the ambient operating temperature of the KVM switch (32°F to 122°F / 0°C to 50°C).
However, if the temperature reading shown in the Device Information section surpasses 185°F (85°C), you should either cool down the room or shut
down the switch until it cools.
7
4
3
8
5
2
1
6
Fan Speed
Fan speed is automatically adjusted according to temperature.
When the temperature reaches the levels mentioned below,
the KVM switches temperature sensors adjust the fan speed
accordingly.
• If any of the four sensors sense a temperature greater than
89°F (32°C), all of the fans will be set to spin at half speed
• When all four sensors sense the temperature is below 86°F
(30°C), all of the fans will be turned off
• If any of the four sensors sense a temperature greater than
113°F (45°C), all of the fans will be set to spin at full speed
• When all four sensors sense the temperature is below 104°F
(40°C), all of the fans will be set to spin at half speed
85