Verifying Post-Installation Connectivity; Electrical And Environmental Specifications; Regulatory Model Number - HPE Aruba Networking 580EX Series Installation Manual

The AC port's PE and AP ground is connected together in the AP. Users can decide if the AC port's PE shall be
connected to the power outlet according to the requirement of the local AP power system or the local
electrician's guidance.
Software
For instructions on choosing operating modes and initial software configuration, refer to the AP Software Quick
Start Guide.
HPE Aruba Networking access points are classified as radio transmission devices, and are subject to government
!
regulations of the host country. The network administrator(s) is/are responsible for ensuring that configuration
and operation of this equipment is in compliance with their country's regulations. For a complete list of
approved channels in your country, refer to the HPE Aruba Networking Downloadable Regulatory Table at
www.arubanetworks.com/techdocs/DRT/Default.htm

Verifying Post-Installation Connectivity

The integrated LEDs on the access point can be used to verify that the access point is receiving power and
initializing successfully (see
on verifying post-installation network connectivity.

Electrical and Environmental Specifications

Electrical
Ethernet

E0 PoE+ port: 100/1000/2500/5000Base-T auto-sensing MDI/MDI-X wired network port (RJ45). The E0 port

supports PoE-in, allowing the AP to draw power from an 802.3at/802.3bt PoE power source.
E1 SFP+ port: 10GBASE-R SFP+ port.

E2 PSE port: 100/1000Base-T auto-sensing MDI/MDI-X wired network port (RJ45). The AP supports 802.3af

PoE-Out when PoE powered, and supports up to 802.3at when powered by AC.
Power over Ethernet (PoE): 57V max, 0.3A

Power

AC input: 100-240V, 50-60Hz, 1.4A

Environmental
Operating

Temperature: -40ºC to 65ºC (-40ºF to 149ºF)

If the 580EX Series access point is deployed supporting Fiber, PSE, and high user loads in extremely hot
temperatures or in hot environments with large solar loading environments, it is strongly recommended to
enable Intelligent Power and Temperature Monitoring (IPTM) to ensure continuous uninterrupted operations,
allowing the AP to disable specific and user-definable features to ensure continuity and prevent a thermal
shutdown of the AP.
Storage

Temperature: -40ºC to 70ºC (-40ºF to 158ºF)

Humidity: 5% to 93% non-condensing

For additional specifications on this product, please refer to the data sheet at www.arubanetworks.com.

Regulatory Model Number

HPE Aruba Networking 580EX Series Hazardous Location Outdoor Access Points
Table 1 and Table 2). Refer to the AP Software Quick Start Guide for further details
| Installation Guide
https://
11