Table of Contents
Advertisement
4. Use a Philips screwdriver to fasten the screws into the wall anchors to secure the mount bracket
on the wall
Figure 6 Screwing Mount Bracket to Wall
5. Align the access point with the mount bracket, placing the access point so that it's mounting tabs
are at an angle of approximately 30 degrees to the mount bracket.
6. Pushing towards the wall, rotate the access point clockwise until it clicks into place.
Figure 7 Attaching AP to Mount Bracket
Verifying Post-Installation Connectivity
The integrated LED on the access point can be used to verify that the access point is receiving power
and initializing successfully .
HPE Networking Instant On Access Point AP21 | Installation Guide
11
Advertisement
Table of Contents
