Table of Contents
Advertisement
Figure 7
Connecting the Fiber-optic Cable
The fiber-optic cable is not included in the package and must be purchased separately. Purchase a suitable 6.5-
14 mm diameter, UV-resistant, outdoor rated cable for use with the access point.
HPE Aruba Networking provides a CKIT-EX-OD-SFP SFP gland kit (sold separately) to connect the fiber-optic cable
to the AP. Refer to the 580EX Series ordering guide on the HPE Aruba Networking website
www.arubanetworks.com.
shown in
Figure 8
To connect the fiber-optic cable to the access point, perform the following steps.
1. Remove the dust cap from the E1 SFP+ port.
2. Insert the transceiver module into the SFP+ port, and ensure it is in place.
3. Slide the sealing nut, seal A, seal B, gland body, O-ring and SFP extension tube over the fiber-optic cable.
HPE Aruba Networking 580EX Series Hazardous Location Outdoor Access Points
Ethernet Cable and 20A2F Cable Gland Installed to AP
The CKIT-EX-OD-SFP SFP gland kit includes a SFP extension tube and a 20A2F gland, as
Figure
8.
Fiber-optic Cable and CKIT-EX-OD-SFP SFP Gland Kit
Fiber-optic Cable
SFP Extension Tube
O-ring
Gland Body
Seal B
| Installation Guide
https://
Seal A
Sealing Nut
9
Advertisement
Table of Contents
