Standard Compliance - HPE Aruba Networking 580EX Series Installation Manual

Hazardous location outdoor access points

Hide thumbs

Table Of Contents

Table of Contents

Ukraine

Hereby, Hewlett Packard Enterprise Company declares that the radio equipment type [The Regulatory Model

Number [RMN] for this device can be found in the

compliance with Ukrainian Technical Regulation on Radio Equipment, approved by resolution of the CABINET OF

MINISTERS OF UKRAINE dated May 24, 2017, No. 355. The full text of the UA declaration of conformity is

available at the following internet address:

Х'ЮЛЕТТ ПАКАРД ЕНТЕРПРАЗ, 6280 АМЕРИКА ЦЕНТР Д-Р, САН-ХОСЕ, КАЛІФОРНІЯ 95002, США

Special Requirement for Safe Use

WARNING - EXPLOSION HAZARD. DO NOT CONNECT OR DISCONNECT WHEN ENERGIZED



AVERTISSEMENT - RISQUE D'EXPLOSION. NE PAS BRANCHER NI DÉBRANCHER SOUS TENSION



WARNING - POTENTIAL ELECTROSTATIC CHARGING HAZARD - SEE INSTRUCTIONS



AVERTISSEMENT - ÉLECTROSTATIQUE POTENTIEL RISQUE DE CHARGE - VOIR LES INSTRUCTIONS



WARNING – DO NOT OPEN WHEN AN EXPLOSIVE ATMOSPHERE IS PRESENT



AVERTISSEMENT - NE PAS OUVRIR LORSQUE UN EXPLOSIF L'ATMOSPHÈRE EST PRÉSENTE



The connections on this equipment are not intended to be connected or disconnected when an explosive



atmosphere is present.

Only EX-certified personnel are allowed for on-site installation and electrical connections of equipment.



Manual switch TPS3851H18EDRBR is protected by at least an IP66 enclosure, it is not allowed to operate the



switch in a hazardous area.

Type-C USB port is protected by at least an IP66 enclosure, and it is not allowed to be used in hazardous area.



Wipe with a wet cloth and use PPE for routine maintenance.



Required protection shall be applied to avoid the high risk of mechanical damage occurred by the final



installation.

Use cable gland, stopping plug, conduit fitting or similar device with ingress of protection of IP66, and the



installation shall meet the requirements of CEC (for Canada) and NEC (for USA) for wiring method in Division

2 and is subjected to acceptance of local authorities having jurisdiction.

The equipment must be installed and used in an area of at least pollution degree 2, as defined in IEC 60664-1.



Only ATEX/IECEx certified cable glands as specified in the instructions are to be installed and used on the



enclosure, and IEC/EN 60079-14 shall be observed when installing. Suitable type of protection cable gland to

be selected with spec: M20x1.5 with minimum IP66 rating. Unused cable entry ports to be blocked by Ex

plugs with minimum IP66 rating.

Earthing system shall be finished in accordance with user manual before use.



Damaged Protective Vents have to be replaced immediately.



The products have been evaluated for use at altitudes not exceeding 3000 m.

