Installation / Service For Halogens - Heat & Glo SUPREME-I25-IFT Installation Manual

D. Installation / Service for Halogens
On units already installed, removal of decorative barrier
front and gas insert may be required.
Option 1:
• Detach flexible liner from top of unit if insert is installed by
removing the collar slide plate screw. See Figure 5.1.
• Remove the five screws on the rear cover plate. See
Figure 6.6.
• Service / replace halogens. Figure 6.2 shows a wiring
diagram.
• Reinstall the rear cover plate back on the unit.
• Reattach flexible liner and replace collar slide plate
screw. See Figure 5.1.
INSTALL HALOGENS
REAR COVER PLATE
Figure 6.6 Cover Plate Removal (Option 1)
Heat & Glo • SUPREME-I25/30/35-IFT, SUPREME-I25/30/35-BIR, SUPRM-I30LP-IFT Installation Manual • 2532-980 Rev. AD • 3/24
Option 2:
• Remove appliance front, glass, logs, base pan assem-
• Service / replace halogens. Figure 6.2 shows a wiring
• Reinstall valve plate assembly, burner assembly, base
OPTION 1
Figure 6.7 Through Valve Plate Opening (Option 2)
bly, burner assembly and valve plate assembly. See
Figure 6.7.
diagram.
pan assembly, logs and appliance glass and front.
INSTALL HALOGENS
OPTION 2
31