Heat & Glo SUPREME-I25-IFT Installation Manual page 44

LOG #2: With the bark end of Log #2 towards the back of the firebox, set the log onto the burner behind log pins B and C
as shown in Figure 13. Rotate the log counter clockwise so that it contacts the air scoop, along with pins B and C.
LOG #3: With the burnout of Log #3 facing left, set the large end against log pin D, place the small end on the flat spot of
Log #1. See Figure 14.
B B
LOG PINS
Figure 13 Log #2 Installed
LOG #4: Set the non-Y end of Log #4 on the flat spot of Log #1. The end of the log #4 will sit flush with the back of Log #1.
The Y-end of log #4 will sit on the flat spot of Log #2. See Figure 15.
LOG #5: The non-burnout end of log 5 will sit on the flat spot of log 3. The corner of the other end will sit on the base
refractory grout line. See Figure 16.
4 4
1 1
LOG DOES NOT CONTACT BASE REFRACTORY
Figure 15 Log #4 Installed
Heat & Glo • SUPREME-I25/30/35-IFT, SUPREME-I25/30/35-BIR, SUPRM-I30LP-IFT Installation Manual • 2532-980 Rev. AD • 3/24
44
AIR SCOOP AIR SCOOP
2 2
C C
BURNER SCREW
REFERENCE
2 2
1 1
Figure 14 Log #3 Installed
4 4
Figure 16 Log #5 Installed
2 2
3 3
D D
3 3
GROUT LINE GROUT LINE