Checking The Product After Repair - Tiso GLASSGO-S Operation And Installation Manual

1 2
Turnstile is not
9
unlocked
The Control panel
10 beeps
"Communication"
The Indication does
11
not work
Rotor stays in half
12
opened position.
The rotor rotates
13
slowly
Rotor do not return to
center (standby)
14
position following a
passage
Rotor gets stuck
15 intermittently during
rotation
Turnstile unlocks but
16
motor does not work
Rotor keeps moving
17 without stop at center
(standby) position

6.3. Checking the product after repair

The turnstile is checked for operability with the help of the remote control after the repair according to Table 4.
3
Have no a communication between
controllers
The turnstile is not receiving
an activation signal from the
Access Control System.
The Control panel have no
communication with the controller
Have no a communication with the
controller
Damaged the wires
The LED indicator is faulty
The position sensor is set wrong
The position sensor is faulty
Jamming in the mechanism
Jamming in the mechanism
The sensor of position/speed is set
wrong
Jamming in the mechanism
The position sensor is set wrong
The PCB.201.01.00.00 is faulty
Jamming in the mechanism
The position sensor is set wrong
The PCB.201.01.00.00 is faulty
The position sensor is set wrong
The PCB.201.01.00.00 is faulty
The position sensor is set wrong
Damaged wires between sensor and
controller
The position sensor is faulty
Operation Manual
4
Check the connectors and wires between
controllers (boards)
Check and clean fault latches
Adjust or replace the position sensor
Check and clean the locking solenoid
Check that the access control system is properly
connected to the Entry Accept terminal(s) on the
controller board.
Check that the access control system is providing
a proper activation signal to PCB 112
Check the wires
Check the control panel
Check the controller
Change the controller/ control panel
Check the wires
Check the LED indicator
Replace the faulty LED indicator
Adjust the position sensor
Replace the faulty position sensor
Check the mechanism parts
Check for rubbing and damages at the
mechanism
Check the rotor parts
Adjust or replace the position sensor
Check the wires
Check for mechanical jamming and damages at
the mechanism
Check the mechanism parts
Adjust or replace the position sensor
Check the connectors and wires
Check for mechanical jamming and damages at
the mechanism
Check the mechanism parts
Adjust or replace the position sensor
Check the wires
Check or replace PCB.201.01.00.00
Adjust or replace the position sensor
Check and adjust the driving belt tension
Check or replace PCB.201.01.00.00
Check or replace gear motor
Adjust or replace the position sensor
Check the connectors and wires
30
Continued Table 12