Advantech ASMB-927 Series User Manual page 68

– SATA Configuration
Enable or disable SATA devices.
– SATA Mode Selection
Set as AHCI or RAID when SATA controllers are enabled.
– Support ALPM
Enable or disable Aggressive Link Power Management (ALPM) protocol for
Advanced Host controller Interface-compliant (AHCI) Serial ATA (SATA)
devices.
– SATA Port 0~7(SATA port 0~3 are for Controller 1, SATA port 4~7 are for
Controller 3)
Enable or disable SATA port 0~7.
– Hot Plug Port 0~7 (SATA port 0~3 are for Controller 1, SATA port 4~7 are
for Controller 3)
Designates SATA port 0~7 as hot pluggable. "Disabled" is the default setting.
– SATA Port 0~7 Spin Up Device (SATA port 0~3 are for Controller 1, SATA
ports 4~7 are for Controller 3)
On an edge detect from 0 to 1, the PCH starts a COM RESET initialization
sequence to the device. "Disabled" is the default setting.
– SATA Port 0~7 Device Type (SATA port 0~3 are for Controller 1, SATA
port 4~7 are for Controller 3)
To identify the SATA is connected to Solid State Drive or Hard Disk Drive.
PCH sSATA/M.2 Configuration (sSATAO and M.2 are for Controller 2)

– sSATA/M.2 controller
Enable or disable sSATA/M.2 controller.
– SATA M.2 Port
Enable or disable SATA port.
ASMB-927 User Manual 60