Advantech ASMB-927 Series User Manual page 49

COM1 Console Redirection Settings

– Terminal Type
Select a terminal type to be used for console redirection.
Options available: VT100 / VT100+ / ANSI / VT-UTF8.
– Bits Per Second
Select the baud rate for console redirection.
Options available: 9600 / 19200 / 38400 / 57600 / 115200.
– Data Bits
– Parity
A parity bit can be sent with the data bits to detect some transmission errors.
Even: parity bit is 0 if the number of 1's in the data bits is even.
Odd: parity bit is 0 if number of 1's the data bits is odd.
Mark: parity bit is always 1. Space: Parity bit is always 0.
Mark and Space Parity do not allow for error detection.
Options available: None/Even/Odd/Mark/Space.
– Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow
devices may require more than 1 stop bit.
Options available: 1/2.
– Flow Control
Flow control can prevent data loss from buffer overflow. When sending data,
if the receiving buffers are full, a 'stop' signal can be sent to stop the data
flow. Once the buffers are empty, a 'start' signal can be sent to re-start the
flow. Hardware flow control uses two wires to send start/stop signals.
Options available: None/Hardware RTS/CTS.
41 ASMB-927 User Manual