Table of Contents
Advertisement
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
INSTRUCTIONS
This equipment is for professional use only.
Read all instruction manuals, tags, and labels before operating the equipment.
Use the equipment only for its intended purpose. If you are uncertain about usage, call your Graco
distributor.
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
Check equipment daily. Repair or replace worn or damaged parts immediately.
Do not exceed the maximum working pressure of the lowest rated system component. This equip-
ment has a 5000 psi (34 MPa, 345 bar) maximum working pressure at 100 psi (0.7 MPa, 7 bar)
maximum incoming air pressure .
Do not exceed the maximum temperature rating of the lowest rated system component. This equip-
ment has a maximum temperature rating of 120 F (49 C).
Never operate the pump without the automatic pressure relief valves installed. These valves relieve
fluid pressure through a drain port at the bottom of the valve if the displacement pump pressure
exceeds the maximum working pressure.
Do not touch the heater during operation; it is very hot.
Do not lift pressurized equipment.
Do not lift the equipment by the Premier air motor lift ring. See page 9 for suggestions for moving
or lifting equipment.
Use only Graco approved hoses. Do not remove hose spring guards, which help protect the hose
from rupture caused by kinks or bends near the couplings.
Route the hoses away from the traffic areas, sharp edges, moving parts, and hot surfaces. Do not
expose Graco hoses to temperatures above 180 F (82 C) or below –40 F (–40 C).
Use fluids and solvents that are compatible with the equipment wetted parts. See the Technical
Data section of all the equipment manuals. Read the fluid and solvent manufacturer 's warnings.
Comply with all applicable local, state and national fire, electrical and other safety regulations.
WARNING
Advertisement
Table of Contents
