12 SERVICE WORK ON THE CHASSIS
68
Info
The heim joint for the shock absorber on the link fork
is Teflon coated. It must not be lubricated with grease,
nor with any other lubricants. Lubricants dissolve the
Teflon coating, thereby drastically reducing the service
life.
–
Position the right side cover on the tail section.
Position the right side cover correctly behind the spoiler.
Ensure that it is correctly seated on the tail section.
–
Mount and tighten screw
Tighten screw hand-tight.
–
Mount and tighten screw
Guideline
Screw, sub-
I00439-11
frame, top
–
Slide the license plate holder with tail light carefully onto the
tail section.
Pay attention to cable routing.
–
Fit and tighten screws
Guideline
Remaining screws,
chassis
–
Connect the plug-in connections for the tail light and turn sig-
nals and secure and stow them well.
I00442-10
–
Fit and tighten screws
Guideline
Remaining screws,
chassis
–
Fit and tighten screws
Guideline
Remaining screws,
chassis
Finishing work
–
Install the main silencer. (
–
Install the frame protector. (
–
Mount the seat. (
–
Remove the motorcycle from the lift stand. (
4
.
5
.
M8
35 Nm (25.8 lbf ft)
Loctite
6
.
M6
10 Nm (7.4 lbf ft)
7
.
M6
10 Nm (7.4 lbf ft)
8
.
EJOT PT
®
2 Nm (1.5 lbf ft)
K60x25‑Z
p. 74)
p. 70)
p. 69)
p. 58)
®
243™