Harman Kardon AVR 520 Owner's Manual page 35

Advanced Features
To change the length of time that the semi-OSD
displays remain on the screen, go to the
ADVANCED menu as outlined earlier, and
press the A/v Buttons _ as needed, until
the on-screen • cursor is next to the SEMI
OSD TIME OUT line. Next, press the,l•
Buttons _ until the desired time in sec-
onds is displayed. Note that unlike most of the
other options in this menu, this is a permanent
setting change, and the time-out entry will
remain in effect until it is changed, even when
the unit is turned off.
If you wish to makeother adjustments, p ress
the A/v Buttons _ until the on-screen•
cursoris next to the desiredsettingor the
RETURN TO MASTER MENUlineand
pressthe Set Button qi_. If you haveno
other adjustments to make,pressthe OSD
Button _ to exit the menu system.
FulI-OSD Time-Out Adjustment
The FULL OSD menu system is used to sim-
plify the setup and adjustment of the AVR 520,
using a series of on-screen menus. The factory
default setting for these menus leaves them on
the screen for 20 seconds after a period of
inactivitybefore they disappear from the screen
(Time-Out). Time-Out is a safety measure to
prevent image retention of the menu text in
your monitor or projector, which might happen
if it were left on indefinitely. However, some
viewers may prefer a slightly longer or shorter
period before the Time Out display.
Tochangethe FuII-OSD Time-Out, y ou will need
to makean adjustmentin the ADVANCED
menu (Figure9).Tostart the adjustment,press
the OSD Button _ to bring the MA ST ER
menu to the screen.Pressthe • Button _t
six times,until the on-screen• cursoris next
to the ADVANCED line. Pressthe Set
Button @ to enterthe AD VA NCE D menu
(Figure9).
Atthe ADVANCED menu (Figure9) make
certainthat the on-screen• cursoris next to
the FULL OSD TIME OUT line by press-
ing the A/• Buttons_ as needed.Next,
pressthe _i/• Buttons qi_/_ until the
desiredtime is displayedin seconds.Notethat
unlike mostof the other optionsin this menu,
this is a permanentsettingchange,andthe
Time-Outentrywill remainin effect until it is
changed,evenif the unit is turned off.
If you wish to makeother adjustments, p ress
the A/• Buttons _ until the on-screen•
cursoris next to the desiredsettingor the
RETURN TO MASTER MENU line and
pressthe Set Button li_. If you haveno
other adjustments to make,pressthe OSD
Button _ to exit the menusystem.
|
!
35 ADVANCED FEATURES