Minolta MN4KPRO User Manual page 16

2. First Use
charging indicator light will light up red while charging and will turn off when
charging is complete.
To attach the wind-guard, simply slide the foam wind-guard onto the
microphone. The stereo microphone can be attached in a number of
locations, it can be attached directly to the camcorder in the hot shoe mount,
or it can be attached to any of the three mounting ports on the handheld
stabilizer. Follow the steps below to attach the video LED light to the
camcorder.
1. Slide the stereo microphone mounting tab into the mounting position on
either the camcorder or the accessories.
2. Rotate the locking screw on the stereo microphone, located right above
the mounting tab, clockwise until tight. Make sure not to overtighten the
screw as this may result in damage.
3. Plug the cable that is attached to the stereo microphone into the
microphone port on the camcorder located under the jack door located on
the side of the camcorder.
4.
5. To remove the stereo microphone, rotate the locking screw counter
clockwise until loose, then slide the stereo microphone out of the mounting
position where it is attached.
15