Matrox Meteor-II Installation Manual page 23

- Make sure the connection at the back of the monitor is firmly in place.
If your monitor uses BNC input, make sure the Red (R), Green (G), Blue (B),
Horizontal Sync (HSYNC – white or gray wire), and Vertical Sync (VSYNC –
black wire) connections are firmly in place and plugged into the correct input.
• If your monitor uses BNC input, one or more connection settings might be
incorrect.
- Set each of your monitor RGB input and sync switches (if available) to 75 ohms,
with the sync set to "external". These controls are usually switches at the back
of your monitor.
• If display problems occur after the startup screen of your operating system, your
software monitor settings might be incorrect.
- Make sure correct software monitor settings are selected. If your primary display
is still usable, see Monitor setup in Chapter 3. Otherwise, see the next
troubleshooting item.
Common problems and solutions 23