Dualhead Multi-Display Setup - Matrox Meteor-II Installation Manual

2. If you have a Plug-and-Play monitor, make sure the Plug-and-Play (DDC)
monitor button is selected. If so, the Matrox display driver automatically uses the
correct settings for your monitor. If the button is not selected, click it and then
click Apply.
If you do not have a Plug-and-Play monitor, ensure the Default monitor (60 Hz)
button is selected, and then proceed to use the Matrox monitor selection method.
For more information on Matrox monitor selection, see Matrox PowerDesk online
documentation.

DualHead Multi-Display setup

With your Matrox graphics board, you can enable a second display (for example,
a computer monitor or a TV) as part of your Windows desktop. This is the Matrox
DualHead Multi-Display feature.
When you first restart your computer under Windows 98/Me/2000/XP, you will
be prompted to enable the DualHead Multi-Display feature. Follow the on-screen
instructions. For more information, see the online help.
Under Windows NT 4.0, follow the steps below:
1. Access the Matrox PowerDesk DualHead property sheet (see Accessing Matrox
PowerDesk property sheets earlier in this chapter).
2. Select the DualHead Multi-Display option button.
3. Click OK and then Yes to restart your computer, and for changes to take effect.
4. Access the Matrox PowerDesk Settings property sheet (see Accessing Matrox
PowerDesk property sheets earlier in this chapter).
5. Click Multi-Display Desktop (
6. Move the Desktop area slider to adjust your multi-display desktop, and then click
OK to accept your changes.
O In multi-display mode under Windows NT 4.0, the same display resolution and
color palette is used for each display.
Configuring your display
).
17