Table of Contents
Advertisement
10-2 Auto Datalogger ( Set sampling time
a. Start the datalogger
Press the " LOG Button " ( 3-8, Fig. 1 ) > 2 Sec. , the LCD will
show the text " Scan Card ", then back measure value, and LCD
up block will show text " LOGGER " will flashing,
at the same time the measuring data along the time
information will be saved into the memory circuit.
Remark :
How to set the sampling time, refer to Chapter 12-3 page 41.
*
How to set the beeper sound is enable, refer to
*
Chapter 12-5, page 42.
b. Pause the datalogger
During execute the Datalogger function , if press the
" Logger Button " ( 3-8, Fig. 1 ) once will pause the
Datalogger function ( stop to save the measuring data
into the memory circuit temporally ). In the same time
the text of " LOGGER " will be no flashing.
Remark :
If press the " Logger Button " ( 3-8, Fig. 1 ) once again
will execute the Datalogger again, the bottom text of "
LOGGER " will flashing .
c. Finish the Datalogger
During pause the Datalogger, press the " LOG Button "
( 3-8, Fig. 1) continuously at least two seconds, the " REC "
indication will be disappeared and finish the Datalogger.
≧
33
1 second )
Advertisement
Table of Contents
