Mode Selection - Lutron Electronics WAC-2019SD Operation Manual

4. MODE SELECTION

1) Turn on the meter by pressing the " Power Button "
( 3-2, Fig. 1 ) > 2 seconds.
Pressing the " Power Button " ( 3-2, Fig. 1 )
*
continuously and > 2 seconds again will turn off the meter.
2) The meter at same time can measure three kind measure Mode
and can select eight kind screen as listed below :
Pressing and hold the " Function Button " ( 3-6, Fig. 1 ), the meter
Display will show the following screen in sequence :
a. pH, mV ( ORP )
b. Conductivity.
c. Dissolved Oxygen
d. pH/ Conductivity
when the screen show the desired Function, just release the
" Function Button "( 3-6, Fig. 1 ), the meter will show this function
measure screen with default.
*Although select single function measure screen, but other
function measure , still being executed.
e. Conductivity/oxygen
f. pH/ Oxygen
g. pH/ Conductivity/Oxygen
h. pH/Temp./ Conductivity/Oxygen
12