Midi Parameters - Yamaha DTXTREME Reference Manual

MIDI Parameters

You can specify for each MIDI channel whether
to enable the sending of MIDI messages, output
values for program changes, control changes,
and so on.
[MIDI1] MIDI SETUP1
Specify up to 16 program change messages that
will be sent out when you switch from the
current drum kit to another. This is very useful
when selecting several programs at a time on the
DTXTREME tone generator as well as external
MIDI devices under the control of the DTXREME.
Program changes specified here will be sent to
the DTXTREME tone generator and output from
MIDI OUT except when the MIDI channel is set
to "10," the basic channel of the drum kit. If the
MIDI channel is set to "10," the specified
program change message is only output from
MIDI OUT and does not affect the drum kit itself.
1 2 3
1 Ch= (Target Channel)
Specify the MIDI channel for sending a MIDI
message.
Settings: 1 – 16
n First select a MIDI channel here, and then set the
contents to send out on that channel using the
following parameters. Repeat this procedure for each
channel (1 – 16) as necessary.
2 Transmit
Enable or disable outputting MIDI messages on
the specified channel. When this parameter is set
to "on," MIDI transmission (to MIDI OUT and
DTXTREME tone generator) on the specified
channel is enabled. Setting "off" disables all MIDI
transmissions on that channel and any following
MIDI parameters become unavailable.
Settings: on, off
3 PC# (Program Change)
Specify a program number you want to output
when switching from the current drum kit to
another. By simply selecting another drum kit on
the DTXTREME, you can conveniently change
programs on other MIDI devices including
synthesizers. Also notice you can set up to 16
program changes for each drum kit.
4 BankMSB (Bank Select MSB)
Combined with the BankLSB parameter, you can
output a bank select message when switching
from the current drum kit to another. This is
especially useful when selecting voices in banks
on a tone generator with multiple sound (voice)
banks. Combine this parameter with the PC# and
BankLSB parameters to specify a sound from a
specific bank of a MIDI device that is set to a
specific (current) MIDI channel. You can set a
bank select message for each MIDI channel.
5 BankLSB (Bank Select LSB)
4 5
Combined with the BankMSB parameter, you can
output a bank select message when switching
from the current drum kit to another. This is
especially useful when selecting voices in banks
on a tone generator with multiple sound (voice)
banks. Combine this parameter with the PC# and
BankMSB parameters to specify a sound from a
specific bank of a MIDI device that is set to a
specific (current) MIDI channel. You can set a
bank select message for each MIDI channel.
50
Settings: 001 – 128
Settings: 000 – 127
Settings: 000 – 127