Yamaha DTXTREME Reference Manual page 46

[Voice3] VOICE3
Set the stereo panning and filter for each MIDI
note number (drum pad). If you have chosen a 2-
layered voice, you can also specify output
volume of each layer.
1 2 3
1 Note Number & Name
Choose a target MIDI note number. Each note
number has a specific note name (shown in the
LCD) as found in the [VOICE1] page.
Settings: 13C#-1 – 94A#5
2 Pan
Adjust the pan setting for the voice you have
chosen. This setting determines the stereo
positioning of the voice.
Settings: L64 – C – R63 (left to center to right)
3 Layer
Specify the output volume of each layer if you
have chosen a 2-layered voice. A value of "0" will
apply the same volume level (50:50) to each
layer. If the voice is not 2-layered, this parameter
is not editable.
Settings: -64 (100:0) – 0 (50:50) – +63 (0:100)
4 Filter
Adjust the filter setting for the voice you have
chosen. This low-pass filter that cuts the
frequencies higher than a specified point (cut-off
point) and passes the rest. By combining with the
"Q" parameter, you can use these parameters to
provide unique sonic characteristics to your
voice.
4 5
5 Q
Adjust the Q (quality) factor around the cut-off
point. By boosting around the cut-off point, you
will adjust the curve portion as shown above,
and can give unique characteristics to your voice.
46
Low-pass filter and frequencies
Level Frequencies passed
by the filter
Cut-off point
Q (Q curves)
Level
Settings: -64 – +63
Settings: -64 – +63
Blocked frequencies
Frequency
Q max.
Q min.
Frequency