System; [Ut 5] System - Yamaha DTXTREME Reference Manual

3 Swap L/R
Reverse the left and right positions of the drum
voices.
off: Position are normal.
on: Positions are reversed.
Settings: off, on
4 RevBypas
Enable or disable bypassing the reverb unit. If
bypassed, all audio outputs will not be applied
the reverb effect (system effect).
off: System reverb effect is available.
on: System reverb effect is unavailable.
Settings: off, on
n Every time you turn the DTXTREME on, this
parameter is automatically set to "on."
[UT 4] TG2
Set the individual output parameters here.
1
1 IndivOut
Set the signals sent to the INDIVIDUAL OUTPUT
jacks.
manual: Output routing for each MIDI note
number (voice) is specified with the Output
parameter in the [Voice6] page in Drum Kit Voice
Edit mode.
auto: The SNARE, KICK, TOM, HI-HAT,
CYMBAL, MISC are sent respectively to Individual
Outputs 1 to 6. However, if the Insertion Effects
are applied, their settings determine the output
routing for each voice.
Settings: manual, auto
2
2 Slider
Set what is controlled by moving the panel slider
(SNARE, KICK, TOM, HI-HAT, CYMBAL or MISC)
while holding down the SHIFT button.
RevSend: Reverb send level of each part.
indiv: Output volume levels of Individual
Outputs 1-6 (1: SNARE, 2: KICK, 3: TOM, 4: HI-
HAT, 5: CYMBAL, 6: MISC).
Settings: RevSend, indiv

SYSTEM

Set the system-wide settings of the DTXTREME,
including display, triggering, factory setting and
so on.

[UT 5] SYSTEM 1

In this page, you can choose the LED indication
and Individual Output settings. The available
parameters are as follows.
1
1 LEDdisp
Choose the message shown in the LED.
drumkit: Shows the current drum kit number.
tempo: Shows the current tempo.
Settings: drumkit, tempo
72
2 3