Machine Translated by Google
MP3 530 hpe
water pump
expansion
Special tool
020661Y Kit for replacing the integral seal of the water pump
- Using a screwdriver, remove the six
Remove screws and the pump cover.
- With an 8mm wrench, the impeller of the Was
Unscrew the water pump.
- Use two flat head screwdrivers. The
screwdriver as shown in the illustration
put so that it can be levered on the edge of the housing
the can, and the integral seal that is on the
If the impeller shaft is pressed on, destroy it.
DANGER
FOR PROTECTION, APPLY TEFLON TAPE AS SHOWN IN
THE PICTURE TO COVER THE SEALING SURFACE
DO NOT DAMAGE WATER PUMP COVER.
POSSIBLE SMALL IMPRINTS ON THE EDGE OF THE SUPPORT
WILL NOT CAUSE MALFUNCTION.
Motor
AGAINST - 225