PIAGGIO MP3 530 hpe Service Station Manual page 149

Machine Translated by Google
Motor
- Heat the countershaft bearing seat.
- The bearing of the countershaft with the specified
Use the specified special tool.
ANNOTATION
THE BALLS MUST BE VISIBLE FROM THE REAR GEAR
(THIS REQUIREMENT APPLIES TO ALL BEARINGS WITH
PLASTIC CONTAINERS).
Special tool
020376Y Handle for adapter
020359Y Adapter 42 x 47 mm
020363Y Guide 20 mm
- The bearing seat of the wheel axle bearing on the housing
heat.
- Remove the wheel axle bearing with the special tool
Insert the upper seat on the housing.
ANNOTATION
THE BALLS MUST BE VISIBLE FROM THE REAR GEAR
(THIS REQUIREMENT APPLIES TO ALL BEARINGS WITH
PLASTIC CONTAINERS).
Special tool
020376Y Handle for adapter
020359Y Adapter 42 x 47 mm
020412Y Guide 15 mm
- Install the circlip of the bearing of the guided
pulley shaft.
ANNOTATION
NOTE THE INSTALLATION POSITION SHOWN IN THE
ILLUSTRATION.
- The shaft seal of the guided belt pulley
Insert it from the drive side.
AGAINST - 152
MP3 530 hpe