PIAGGIO MP3 530 hpe Service Station Manual page 208

Machine Translated by Google
MP3 530 hpe
countershaft
- Using a micrometer, check the 2 running surfaces of the front
Measure layshaft (see illustration).
Technical specifications
Standard diameter:
17 - 0,01 - 0,02 mm
- Check that the water pump driver shows no signs of wear.
Installation of crankshaft
- Check that the drive gear of the countershaft and oil pump is not damaged or damaged
is formed. Replace if necessary.
ANNOTATION
IF THE COUNTERSHAFT DRIVE GEAR AND OIL PUMP IS REPLACED, THE COUNTERSHAFT GEAR
MUST ALSO BE REPLACED.
- Before installing the gear on the crankshaft
The mating surfaces must be carefully cleaned and
Remove LOCTITE residue from the holes with a brush
removed.
Blow through the mounting holes on both surfaces with compressed air and degrease so that the
new LOCTITE finds support.
Attach the recommended product to the holes again.
Recommended products
Loctite 243 Medium strength thread locking sealant.
Colour blue
- Repeat the same steps on the 4 fastening screws.
- Place the drive gear on the crankshaft. The bevel with the holes must be visible
be cash.
- Tighten the 4 fastening screws to the specified torque.
ANNOTATION
BE CAREFUL NOT TO DAMAGE THE ALLEN INSERT. IF POSSIBLE, USE A SOCKET WITH A SOCKET
ATTACHMENT.
Motor
AGAINST - 211