Mounting - insys icom MRX Installation And User Manual

MRX
10

Mounting

This section describes how to mount the MRX to a DIN rail, connect the
power supply and uninstall it again. Observe the instructions in the "Safety"
section of this manual, in particular the "Safety Instructions for Electrical
Installation" for that purpose unconditionally.
Caution!
Moisture and liquids from the environment may seep into
the interior of the device!
Fire hazard and damage of the product.
The device must not be used in wet or damp environ-
ments, or in the direct vicinity of water. Install the device
at a dry location, protected from water spray. Disconnect
the power supply before you perform any work on a device
which may have been in contact with moisture.
Caution!
The device could be destroyed if the wrong power supply
is used!
If the device is operated with a power supply that supplies
a voltage exceeding the permissible operating voltage, it
will be destroyed.
Make sure that you use the suitable power supply. Refer to
the Technical Data section for the proper voltage range.
Caution!
Risk due to mounting failure!
Injury due to falling device.
Make sure to mount the device such that the potential
drop height is below two (2) meters.
Mounting
81