Grounding The Chassis - Cisco Catalyst 8300 Series Hardware Installation Manual

Grounding the Chassis

Figure 19: Showing locations of holes in the brackets that can be used to secure to the wall
Grounding the Chassis
Warning
Warning
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
28
Vertical spacing; hole centre to hole centre
Horizontal spacing; hole center to hole centrer
Statement 1024 Ground Conductor
This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor or
operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical
inspection authority or an electrician if you are uncertain that suitable grounding is available.
Statement 1046 Installing or Replacing the Unit
To reduce risk of electric shock, when installing or replacing the unit, the ground connection must always be
made first and disconnected last.
If your unit has modules, secure them with the provided screws.
Install the Cisco Catalyst 8300 Series Edge uCPE
18.4 inches
12.06 inches