Cisco Catalyst 8300 Series Hardware Installation Manual page 28

Installing the Cisco Catalyst 8300 Series Edge uCPE
Figure 14: Mounting the Chassis on the Rack- Front (I/O face) shown for 23-inches Rack Mount
1
2
Tip
The screw slots in the brackets are spaced to line up with every second pair of screw holes in the rack. When
the correct screw holes are used, the small threaded holes in the brackets line up with unused screw holes in
the rack. If the small holes do not line up with the rack holes, raise or lower the brackets to the next rack hole.
Four-point Mounting in a Cabinet
Four-point mounting is supported for 19-inches cabinets that require rear-support of the device. A range of
rear-support depths is supported depending on whether you choose flush-mounting or recessed-mounting.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
24
Install the Cisco Catalyst 8300 Series Edge uCPE
Securing screws (not included)
23-inches rack upright