Cisco Catalyst 8300 Series Hardware Installation Manual page 30

Install the Cisco Catalyst 8300 Series Edge uCPE
Installing the Cisco Catalyst 8300 Series Edge uCPE
Figure 17: Recessed-Mount Front Bracket Depths
Wall-Mounting the Chassis
Wall-mounting is supported for the device.
For safety reasons, the device must be mounted as shown in the following figure with the I/O-face to the side.
I/O-face may be oriented to the right (as shown) or to the left, but only a side of the chassis may be facing
down.
1. Attach the brackets to the device using the screws provided with the mounting kit.
Two screws should be used to attach each bracket to the chassis as shown in the following figure.
Note The wall-mounting kit is different from the rack-mounting kit.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
26